Top 10 best 52 300 Softballs 2022 Price and Feature Comparison

I have literally tried about 15 different “magnet” type of mounting options. First, I would say most overly extend their actual holding force. Next I would say most aren’t very flexible how they contact the firearm. For example the longer flat ones are not complete magnets they are just a couple little bar magnets glued on plastic with a cheap plastic covering. Unless the firearm can lay flat across the whole surface they don’t hold very well. They also have a tendency to fall apart over time as the cheap glue on the magnets starts to give out and the cover doesn’t stay on so well. Others take a doughnut magnets and put a cheap plastic cover over them. Again glue breaks down and covers come off. Both styles are also thin. Depending how you are mounting, it makes it difficult to get a good quick grip to pull the gun off. None of them are really good with revolvers due to the cylinder sticking out past the frame. I.e limited flat surface for mounting. Depending on the grip panels or safety / mag release buttons and levers on a semi auto gun still may not lay flat enough to get a good mount on the magnet.What is really nice about this one is how it addresses most of the issues. First thing they did is place 2 very strong cylinder magnets next to each other. This maximizes the holding force to a much smaller area. This means a much stronger connection to the gun and the smaller area greatly increases the flexibility to fit some place on the gun. Next they molded a 1 piece body. This removes the issue of having a cheap cover that comes off and breaks over time. Finally they made it so the magnets enter the body from behind. This means that even if the glue breaks down over time the magnets are captured between the body and the mounting surface. No risk of pulling the gun off and the magnets and cover come with it. Depending how you mount this could actually mean you still have to pull magnets and covers off your gun before it works. Not a good risk to take if you assume this could happen in a defensive situation. You also do not have the risk the glue gives way and the firearm falls off the mount. Finally they do provide a little stand off but still provide a low profile. This allows you the ability to make the most contact with the magnetic surface but still lay flat where revolver cylinders, safety levers, mag release buttons are not an issue. It also gives you just enough stand off that my sausage fingers can fit around the grip to pull it out in a ready state. I do not have to still adjust my grip after pulling it out.The one thing I did change is the mounting surface that makes contact with the firearm. It comes in with a harder plastic surface. It probably would not cause wear to the finish, but I am one of those anal retetive people that cleans after every use and do not want extra wear marks / finish damage. I took a few clean patches / wash cloth material and lightly glued it on the mating surface. First this helps protect the finish when taking the gun on and off because I’m “that guy”. The second thing it does is actually make retrieval easier and smoother. The sliding friction is reduced when pulling off but the magnet force to hold the firearm on the mount is still rock solid. Just don’t get crazy and try to put an in inch worth of material on.Overall I am extremely pleased with build quality, simplicity, ease of use, flexibility to attach, and strength of magnetic force. I have already purchased again and will again in the future!

I’m in a men slow soft pitch league and these softballs are perfect for BP with the guys. Must buy

The balls are quality, but they only sent me 10 of the 12 purchased balls.

Bought used and for incredicle price and couldn’t b happier with purchase

Good balls for asa slow pitch. For me good for around 100 hits.